SENSECOM-CMDO-232G4

Code: CMD-020
€158 €191,18 incl. VAT
In Stock (>5 pcs)

Reading 1-15 registers from Metering devices by MODBUS / RS232, uses SIGFOX IoT network, powered ~240Vgalvanic separation of inputs, measurement periods high precision timer (+/- 4sec a day).

Detailed information

Product detailed description

The SENSECOM-CMDO-232G device is designed for data readings via serial RS-232 interface. Data input is galvanically separated. The device is powered from mains.

Applied communication protocol is MODBUS.

The device sends readings from meter registers (or other source device registers) via a nationwide SIGFOX IoT network, directly or via repeater SENSECOM-WSH (for radio-hard-to-reach locations). Messages interval can be setup within the range 10min-24h (minimum 10min per register needs to be consider in setup of an interval) with higher precision of +/- 4sec a day.

Contains supercap (1F) which allows overcome short power outages with signalling power-of status if set.

All SENSECOM-CMD models are manufactured in a DIN casing, 3U width, IP20.

Easy installation on DIN rail by authorized technician (for low voltage 240/380V installations).

Read-out capacity up to 15 registers to be read from source device is configurable via downlink.

Typical applications:

Remote readings from registers of utility meters or other devices possessing serial interface, e.g. electricity meters, gas meters, water meters, calorimeters using standardized registers and protocols.

If vendor specific protocol or use is applied, additional firmware development is needed to support this, ask vendor if this is a case.

 

 

Additional parameters

Category: Registers read-out
Warranty: 2 years
Power supply: Mains (240V)
Meter interface: RS232
Galvanic isolation: Yes
Meter communication protocol: MODBUS
Max number of reading registers: 15
Reading interval (sending data): 10min - 24h
Casing: DIN Rail, 3U width, IP20
Timer precision: +/- 4sec a day